Mary (Data Robotics) - Browse Comments

151 Comments Found    1 2 3 4 5 6 Next »

Reply to Linux and Drobo - Installation on May 9, 2008

The only supported EXT3 format for Drobo is via Drobo Dashboard when Drobo is connected to a DroboShare. Formatting Drobo using your Linux computer in EXT3 is currently in beta. This means that you can...

Reply to Drobo red light. on May 9, 2008

A red light means that you are critically low on space. How full (%) is your Drobo. Was there a yellow light in that slot before the red light came on? With regard to the...

Reply to How to connect to DroboShare on April 3, 2008

Jazzi, formatting the drives in Drobo using Drobo Dashboard or Windows Disk Management Utility should not affect whether DroboShare can or cannot be "seen" by Drobo Dashboard. What I suspect happened was that the Ethernet...

Reply to Official "Decorate Drobo for the Holidays" Contest Thread on December 21, 2007

Well, you all know that I can't participate, but the DRI team did get in the holiday spirit with our own little departmental decorating contest. Here are some of the creative highlights... Engineering brought in...

Reply to Robot Fails to Recognize Drives in Bays #2-4 on December 3, 2007

After you have confirmed that they are SATA drives, then, assuming you do not have any data on the drives yet, I would recommend that you do a factory reset : Here are the instructions...

Reply to Robot Fails to Recognize Drives in Bays #2-4 on December 3, 2007

This does seem odd, Richard45. What type of drives are you using? Make sure they are SATA drives because those are the only types of drives that Drobo can accept.

1 2 3 4 5 6 Next »